Skip to content
Bog & Briar
Menu

Boot Fit & Sizing

Hunting boots with a BOA system

The honest answer to this search is a short list. There is one true BOA hunting boot in general circulation, a work boot that crosses over, and a great many lace-up boots that do the same job for less money.

By Mike M.Last updated

Bog & Briar earns a commission when you buy through our links, at no extra cost to you. Prices come from Amazon and change; the date beside every price is when we last verified it. Full disclosure.

Zamberlan Lynx Mid GTX BOA from Zamberlan
Zamberlan Lynx Mid GTX BOA from Zamberlan

BOA buying guide

Zamberlan Lynx Mid GTX BOA

9.1/10

The only true BOA hunting boot listed

If you specifically want a BOA dial on a hunting boot rather than on a work boot, this is effectively the single listing that qualifies: a Gore-Tex mountain boot with a dial instead of laces, at a mountain-boot price.

Quick picks

#ProductShaft heightScorePrice
Rank 1
Zamberlan Lynx Mid GTX BOA from Zamberlan

Zamberlan Lynx Mid GTX BOA

The only true BOA hunting boot listed

Mid9.1/10$500.00Amazon
Rank 2
Danner Vicious BOA 8-inch from Danner

Danner Vicious BOA 8-inch

A BOA dial you can actually buy today

8 in9.0/10$299.95Amazon
Rank 3
Irish Setter Elk Tracker 12-inch, 1,000g from Irish Setter

Irish Setter Elk Tracker 12-inch, 1,000g

Cold-weather hunts that involve walking

12 in9.6/10$279.95Amazon
Rank 4
Kenetrek Mountain Extreme 400 from Kenetrek

Kenetrek Mountain Extreme 400

Steep country with a heavy pack

10 in9.4/10$404.96Amazon

#ad Prices come from Amazon and change. How this site is funded. Scores are our published editorial rubric — see our methodology.

If you want a BOA dial on an actual hunting boot, the Zamberlan Lynx Mid GTX BOA is effectively the only one in general circulation - a Gore-Tex mountain boot with a dial instead of laces. It is expensive and stock is thin. The practical alternative is the Danner Vicious BOA, which is a Gore-Tex work boot rather than a hunting boot but is reliably in stock, 8 inches tall and several hundred dollars cheaper. If neither appeals, the honest conclusion is that a good lace-up with a heel-lock pattern gives you most of what the dial promises.

This page is a guide rather than a ranking because a ranking would be padding. We swept the market for BOA-equipped hunting footwear and found one genuine hunting model and a handful of work and tactical boots. Ranking two boots and calling it a top five would be dishonest, so here is what exists, what the dial actually does, and when a lace is the better buy.

What a BOA dial actually is

A BOA Fit System replaces laces with a stainless steel lace routed through low-friction guides and tensioned by a reel. You turn the dial to tighten, pull it out to release, and the whole boot loosens at once. BOA Technology licenses the system to boot makers rather than making boots, which is why you see the same dial on snowboard boots, cycling shoes, work boots and - rarely - hunting boots.

The three things it genuinely does better than a lace:

  1. One-handed adjustment, with gloves on. This is the real argument. Mid-stalk, in the cold, you can tension or release the boot without taking a glove off or sitting down.
  2. Even tension across the whole upper. A lace tightens unevenly because friction at each eyelet resists the pull. A reel distributes tension more evenly, which can mean fewer pressure points.
  3. Micro-adjustment. You can add a click of tension on a descent and take it off on the flat, which with laces means stopping and retying.

What exists, and what to buy instead

The one true BOA hunting boot, the work-boot crossover that is actually in stock, and two lace-up boots that do the same job for less.

#1 · The only true BOA hunting boot listed

Zamberlan Lynx Mid GTX BOA

Zamberlan
9.1/10

If you specifically want a BOA dial on a hunting boot rather than on a work boot, this is effectively the single listing that qualifies: a Gore-Tex mountain boot with a dial instead of laces, at a mountain-boot price.

Published specifications
ClosureBOA Fit System dial (manufacturer)
MembraneGore-Tex (manufacturer)
Shaft heightMid
InsulationNot published by manufacturer
ResoleableZamberlan publishes a resoling service

Specifications per Manufacturer figures as published on the Amazon product listing.

What it does well

  • A real BOA dial on a real hunting boot, which almost nothing else in the category offers
  • Gore-Tex lined and built on the European mountain-boot pattern Zamberlan is known for
  • One-handed adjustment with gloves on, which is the entire argument for a dial

Good to know

  • Expensive, and stock is thin - usually a handful of pairs per size at a time

Our rubric — each criterion 0-10

Warmth
5.6
Waterproofing
8.8
Fit
8.6
Durability
8.8
Value
6.0

#2 · A BOA dial you can actually buy today

Danner Vicious BOA 8-inch

Danner
9.0/10

A work boot, not a hunting boot - but it is Gore-Tex lined, 8 inches tall and in stock, which makes it the realistic BOA option if the dial matters more to you than the camo.

Published specifications
ClosureBOA Fit System dial (manufacturer)
Shaft height8 in
MembraneGore-Tex lined (manufacturer)
ToeComposite safety toe
OutsoleVibram, slip resistant (manufacturer)

Specifications per Danner published specifications.

What it does well

  • Reliably in stock, which separates it from every other BOA boot in this category
  • Gore-Tex and a Vibram outsole - the hardware is hunting-grade even if the boot is not
  • Danner's recrafting program applies to its stitchdown work boots

Good to know

  • A composite safety toe is dead weight on a hunt and changes the fit at the front of the boot

Our rubric — each criterion 0-10

Warmth
5.0
Waterproofing
8.6
Fit
7.8
Durability
8.8
Value
7.0

#3 · Cold-weather hunts that involve walking

Irish Setter Elk Tracker 12-inch, 1,000g

Irish Setter
9.6/10

1,000g of insulation in a 12-inch lace-up leather boot: the combination that lets you cover ground in the cold without the sweat-then-freeze cycle a rubber pull-on forces.

Published specifications
Insulation1,000g
Shaft height12 in
UpperFull-grain leather
WaterproofingUltraDry membrane (manufacturer)
FitLace-up

Specifications per Irish Setter published specifications.

What it does well

  • Laces mean you can actually tension the boot to your foot, which is why it walks better than any pull-on
  • 1,000g is the sweet spot for a boot you walk in and then sit in
  • Leather takes a real conditioning treatment and lasts seasons longer than neoprene

Good to know

  • Leather is not scent-free the way rubber is, and it absorbs whatever you walk through

Our rubric — each criterion 0-10

Warmth
8.8
Waterproofing
7.8
Fit
9.2
Durability
9.2
Value
8.2

#4 · Steep country with a heavy pack

Kenetrek Mountain Extreme 400

Kenetrek
9.4/10

A full-shank mountain boot with only 400g of insulation, and that pairing is deliberate: in steep country you generate your own heat and need support, not loft.

Published specifications
Insulation400g Thinsulate
Shaft height10 in
Upper2.8mm full-grain leather
MidsoleFull-length nylon shank
WaterproofingWindtex membrane (manufacturer)

Specifications per Kenetrek published specifications.

What it does well

  • The stiff shank is what stops your feet dying on a sidehill under 60 pounds
  • One-piece leather upper with minimal seams - the fewest failure points here
  • Resoleable, which matters at this price

Good to know

  • The most expensive boot in this registry by a wide margin

Our rubric — each criterion 0-10

Warmth
6.8
Waterproofing
8.8
Fit
9.0
Durability
9.8
Value
6.6

Why there are so few BOA hunting boots

Four reasons, and they are structural rather than temporary:

  • Hunters distrust mechanisms. A dial is a part that can fail five miles from the truck, where a lace can be knotted, replaced with paracord, or simply tied tighter. That perception shapes buying, and buying shapes what gets made.
  • Noise. A ratcheting dial clicks. On a cycling shoe nobody cares; a hundred yards from a bedded buck it is a consideration, even if a small one.
  • Cost. The system adds cost to a category already fighting on price, and the dominant hunting-boot buyer is not paying premium money for a closure.
  • Pull-ons dominate half the market. A large share of hunting boots have no closure at all, and a dial is irrelevant to them.

The one place the dial is winning is work and tactical boots, where gloved one-handed adjustment is a daily requirement and noise is irrelevant. That is why the Danner Vicious BOA exists and why it is the most available option here - with the caveat that it carries a composite safety toe, which is dead weight on a hunt and changes the fit at the front of the boot.

BOA against a well-laced boot, honestly

 BOA dialLaces, heel-lock pattern
Adjust with gloves onYes, one-handedNo
Even tensionBetterUneven by nature
Field repairableNo - carry the warranty cardYes - knot it, or use paracord
Zone-specific tensionNo, unless dual-dialYes - tighten the instep, leave the forefoot
NoiseAudible clickSilent
CostAdds to the boot priceIncluded
Choice of bootsEssentially one hunting modelThe entire market
The dial wins on convenience; the lace wins on choice, repairability and zone control

That last row is the one that decides it for most hunters. Choosing a closure means giving up the choice of boot, and fit matters more than closure by a wide margin. A boot with the right last and the wrong closure will outperform a boot with the right closure and the wrong last every single time. Our BOA versus laces comparison goes deeper on the mechanism; this page is about what you can actually buy.

Get the lace result without the dial

Most people searching for a BOA hunting boot are solving one of two problems, and both have a lace-based answer:

Problem one: the heel lifts

This is the most common reason people want more even tension. The fix is a heel-lock (surgeon's knot) lacing pattern, not a different closure: tighten the lower lace, tie a surgeon's knot at the instep to hold that tension, then lace the upper hooks independently. That locks the heel without compressing the forefoot - which is exactly what people hope a dial will do for them. Add a structured insole if the boot has spare volume.

Problem two: adjusting with cold hands

Real problem, and a dial genuinely solves it. The lace-based workaround is a boot with speed hooks in the upper third rather than eyelets all the way up: you can hook and unhook those with gloves on, even if you cannot retie the bottom. Both the Irish Setter Elk Tracker and the Kenetrek Mountain Extreme use hardware like this.

What we would buy

  • You specifically want a BOA hunting boot: Zamberlan Lynx Mid GTX BOA. Check stock before you commit - it moves in ones and twos.
  • You want the dial and you want it in stock: Danner Vicious BOA 8-inch, understanding that it is a work boot with a safety toe.
  • You wanted the dial to fix heel lift: Irish Setter Elk Tracker with a heel-lock lacing pattern, for less money.
  • You wanted the dial for mountain hunting: Kenetrek Mountain Extreme, which is the boot the dial models are trying to be.

Our recommendation

If you only take one thing from this page, take this one.

Our pick

Zamberlan Lynx Mid GTX BOA

The only true BOA hunting boot listed

9.1/10

Runner-up

Danner Vicious BOA 8-inch

A BOA dial you can actually buy today

9.0/10

Frequently asked questions

Which hunting boots have a BOA system?
Very few. The Zamberlan Lynx Mid GTX BOA is the one true hunting model in general circulation, and the Danner Vicious BOA is a Gore-Tex work boot that hunters use as a crossover. Most BOA-equipped boots on the market are work, tactical or snowboard boots rather than hunting boots.
Is BOA better than laces for hunting boots?
Better at three things: one-handed adjustment with gloves on, even tension across the upper, and micro-adjustment on the move. Worse at field repairability, zone-specific tension, silence and - most importantly - choice, since picking the closure means picking from essentially one hunting boot.
Can a BOA dial fail in the field?
It can. BOA warranties its reels and sells replacement kits, which does not help you five miles out. If you buy one for backcountry use, carry a spare lace and a knife so you can cut the steel lace out and lace the boot through its guides with cord to walk out.
Are BOA boots noisy for hunting?
The dial clicks when you tension it, which is a brief and controllable noise rather than a constant one. It is a minor consideration compared with your outer layers and your footfalls, but it is one reason hunting-boot makers have been slow to adopt the system.
What is the cheapest way to fix heel lift without BOA?
A heel-lock lacing pattern: tighten the lower lace, tie a surgeon's knot at the instep to hold that tension, then lace the upper hooks separately. That holds the heel without compressing the forefoot. If the boot still has spare volume, add a structured insole.

Sources

Danner Pronghorn 800g from Danner

Boot Fit & Sizing

BOA or laces on hunting boots

A dial you can turn with gloves against a system you can fix with paracord. The deciding factor is the failure mode.

Kenetrek Mountain Extreme 400 from Kenetrek

Boot Fit & Sizing

Best mountain hunting boots

The one category where price tracks capability. What a $500 boot does structurally that a $200 boot cannot.

KEEN Revel 4 Mid Polar from KEEN

Boot Fit & Sizing

Hunting boot sizing guide

The sizing adjustment table, the five fit checks, and the two measurements shoe size tells you nothing about.

Crispi Hunter GTX from Crispi

Brands

Crispi vs Kenetrek

Stiffness against supported flex, American last against European. A fit decision rather than a quality one, with the mid-priced alternatives named.

Hunting boots sorted by the problem you actually have — cold feet, wet feet, or snakes.